1. When installing a pull-resistant rubber joint, it is strictly prohibited to install beyond the displacement limitation.

2. The installation bolts of the pulll-resistant rubber joint should be symmetrical and tightened gradually to prevent local leakage.

3. The working pressure is above 1.6MPa, and the installation bolts must have elastic pressure pads to prevent the bolts from loosening during work.

4. When the anti-pull rubber joint is installed vertically, both ends of the joint pipe should be supported by vertical forces, and an anti-pull device can be adopted to prevent the working pressure from pulling off.

5. The installation part of the pull-resistant rubber joint should be far away from the heat source and ozone area, and it is strictly prohibited to expose to strong radiation light and use the medium that does not meet the requirements of this product.

6. The pull-resistant rubber joint is strictly prohibited from scratching the surface and sealing surface with sharp instruments during transportation and handling.

PROPERTIES OF HIGH-PRESSURE PULL-RESISTANT RUBBER FLEXIBLE JOINT：

1. The pull-resistant rubber joint is small, lightweight, flexible, and easy to install and maintain.

2. The pull-resistant rubber joint can produce lateral, axial, and angular displacement when it’s installed, and is not restricted by the pipes that are not through the center and the flanges are not parallel.

3. The pull-resistant joint can reduce the noise transmitted by the structure when working, and has a strong vibration absorption capacity.